Where can I buy a ZERO HALLIBURTON case?
You may purchase in ZERO HALLIBURTON boutiques and/or department store corners. Please kindly check our Store Locations page to find the retailer nearest you.
What is the ZERO HALLIBURTON Limited Lifetime Warranty?
See our Warranty page.
What is the best way to clean aluminum?
To remove dirt or residue, wipe the case clean using a soft, damp cloth. You can shine your aluminum case by applying a coat of mild polish wax that does not contain silica.
Does aluminum scratch or dent?
Yes, it is possible to scratch or dent your aluminum case. While we heat-treat and anodize the aircraft grade aluminum to provide maximum strength to the surface, it is possible that your case will scratch or dent. However, you can rest assured that no matter the bump or bruise, ZERO HALLIBURTON cases will provide superior protection for your contents. Of course, the best way to reduce scratching or denting is by using a little tender loving care. Try to avoid dropping your case off of buildings, throwing it across the room or sliding it across rough or jagged surfaces. For your information, the silver color tends to hide scratches the best. A deep scratch will show silver, therefore, there is not much contrast between the scratch and the silver finish.
How long will the foam insert in my camera case last?
Like any other foam product, the foam in ZERO HALLIBURTON camera cases is subject to degradation. While the foam is chemically stable at room temperature and will perform under a wide range of temperatures, the length of life of the foam can vary widely depending on the care of the product, including but not limited to environmental factors such as extended exposure to UV rays, heat or humidity. If you notice any appearance of fine powder, loss of resiliency, noticeable color change or a consistency change such as a rubbery soft feel, it is time to obtain a replacement set of foam. It is important to note that it is the sole responsibility of the case owner to regularly check for foam degradation and to replace the foam when necessary. ZERO HALLIBURTON is not responsible for any damage sustained to the contents of the case due to foam degradation.
Where can I purchase foam inserts for my camera case?
If you need a replacement set of foam inserts for your camera case, please contact us with your case model or the outside dimensions of your case.
I have had my case for many years and I would like to repair it or get replacement parts.
Where should I go?
While each ZERO HALLIBURTON case has been made to last a lifetime, it should be expected that component parts will show use over time and may eventually need to be repaired or replaced. While this wear occurs normally and is not covered by our warranty, we will be happy to provide you with high-quality service at a reasonable cost. You may contact one of our authorized repair facilities or contact us directly for assistance.
What are the airline standards for carry-on luggage?
Each airline sets own carry-on restrictions. The standards of international flights typically the sum of the dimension is less than 115cm, each dimension should be within 55cm (Height) x within 40cm (Width) x within 25cm (Depth). We recommend that you contact your airline for their policy regarding carry-on luggage.